Product Videos
Questions & Answers
Hi I have a custom fuel tank for my 1958 6-226 wagon it's 10in deep will part# 914848 work
Willys Jeep Parts Tech:
There is no way to tell that for sure since you have something that isnt factory.
There is no way to tell that for sure since you have something that isnt factory.
I was going through the Q & A section and two of the answers conflict each other on the gas gauge ohm readings, one was 7-9 full and 130-140 empty and the other was 8-10 full and 70-80 empty. Coulod you please explain? Thanks, Dale Henry
Willys Jeep Parts Tech:
Its: 8-1/2 - 10-1/2" FULL 70-80 EMPTY
Its: 8-1/2 - 10-1/2" FULL 70-80 EMPTY
Does this sending unit come with the 6 screws? Also will this work in my 1949 jeepster with original fuel tank? Thanks
Willys Jeep Parts Tech:
B0306 is the part number for the screws.
B0306 is the part number for the screws.
Hello, will this sending unit work with the fuel gauge of my 69 Kaiser Wagoneer? Thanks
Willys Jeep Parts Tech:
Sorry, they used a different one.
Sorry, they used a different one.
I need to match an aftermarket fuel gage to this sender. They have all kinds of ohm ratings. Would the standard Ford 73-10 ohms work with this one? or do I need something else?
Willys Jeep Parts Tech:
These are the readings for the gauges: 7-9 Full and 130-140 Empty. Thanks
These are the readings for the gauges: 7-9 Full and 130-140 Empty. Thanks
How do you adjust the reading on the fuel gauge?
Willys Jeep Parts Tech:
There is a small window on the back of your fuel gauge to adjust with a screw driver.
There is a small window on the back of your fuel gauge to adjust with a screw driver.
I have a 1958 willys fc170 , I am looking for a replacement speedometer cluster with temp and fuel sending units. Do you carry these parts? Thanks
Willys Tech:
914850 would be the one you need.
914850 would be the one you need.
Does this sending unit work with your tank # MTS0018 ? If not tell me what is the part number for the sending unit that goes with this tank ?
Willys Tech:
Yes this is the correct sending unit for that tank.
Yes this is the correct sending unit for that tank.
I pulled the tank out of my 1950 Jeepster. It has a smooth flange and no holes for the sending unit. On the sending unit is a steel ring with the 6 screws in it, that was loose. Does this ring tighten to the tank flange when the sending unit is installed?
Willys Tech:
Yes that should be your fuel tank sending unit. It is attached with 6 screws.
Yes that should be your fuel tank sending unit. It is attached with 6 screws.
What are the ohm resistance values for this unit? I am having my guages converted from 6 to 12 volt and need the ohm values to have it correctly calibrated.
Willys Tech:
8-10 Full and 70-80 Empty
8-10 Full and 70-80 Empty
YOU MIGHT ALSO BE INTERESTED IN
