Questions & Answers
I have a 1966 Dana 27 (V6) with the small u-joint drive flange. Will this item allow me to connect to a driveshaft which accepts the larger Spicer 1310 u-joint? Can I connect the larger joint driveshaft to the smaller joint axle flange using this item?
Willys Jeep Parts Tech:
It should. Just make sure your caps match what we list and it will be an exact replacement.
It should. Just make sure your caps match what we list and it will be an exact replacement.
i have a 1968 cj5 and the drive shaft you show show only one size universal joint but my unithas two different size joints. your parts have been wrong previously on my unit. do you have both sizes for the u niversal joints or should i resource elsewhere
Willys Jeep Parts Tech:
The 937340 is the correct joint see the specs on it. The earlier CJ-5 used 8126614S.
The 937340 is the correct joint see the specs on it. The earlier CJ-5 used 8126614S.
Have a 68' with the V6. Looking at the U joints the front appear smaller than the rear. Is this correct and if so, which axle do these fit?
Willys Jeep Parts Tech:
They are typically the same. Please measure your joints and confirm they match up to these. We should be able to help either way.
They are typically the same. Please measure your joints and confirm they match up to these. We should be able to help either way.
I have a 1968 Commando with a 4F cylinder that came stock.. Will these universal joints fit? Application shows V6 engine
Willys Jeep Parts Tech:
Just double check your measurements are the same and it is the correct part.
Just double check your measurements are the same and it is the correct part.
I have a 1960 CJ5 with the F-134 engine. The front driveshaft U-Joint has different sized bearing caps. One cap is 1.063" which attaches to the transfer case yoke and the other cap is .938"diameter, which attaches to the driveshaft. The u-joint's Overall length is 3.218". Is the u-joint available?
Willys Jeep Parts Tech:
That would be unusual in a 1960. Please call us toll free and ask for Mike M. with your measurements. I can try to help out.
That would be unusual in a 1960. Please call us toll free and ask for Mike M. with your measurements. I can try to help out.
I have a 1971 CJ5 with the 4 cylinder engine will these work for front drive shaft it looks good I know it needs 2 internal and two external caps and size looks right . Thanks
Willys Tech:
Yes as long as your measurements match up to the numbers above they will be correct. These are just like original.
Yes as long as your measurements match up to the numbers above they will be correct. These are just like original.