Product Videos
Questions & Answers
Hey Mike! I have a ‘65 CJ5 Tuxedo Park with the single stick D18 behind a T90 (floor shift). Would you know tooth count off hand or should I pull inspection plate to check? I assume I need to drain oil to pull the inspection plate or I will have a big mess, correct? Thanks!
Willys Jeep Parts Tech:
If your a 1965 then you wiill be a 29 tooth count.
If your a 1965 then you wiill be a 29 tooth count.
I just purchased a 1957 FC 150 we found the vin# on the frame but would like a id plate for the cab could you recommend one I dont see it under the FC parts
Willys Jeep Parts Tech:
We sell the most of DATAPLATE-2
We sell the most of DATAPLATE-2
The serial number stamped on the frame of my 1948 willys is c12a177030 , is this a good number ? The title says is a 1948 . Its git the 134 engine , t90 tranny , shifters on the floor , two piece windshield willis stamped under the windshield and on the side of the hood. I just want to know if this is a good serial number . Thanks
Willys Jeep Parts Tech:
Yes but all you need is the 177030 part. If you go to this link, you will be able to match the number up: https://www.kaiserwillys.com/willys_jeep_serial_numbers Thanks
Yes but all you need is the 177030 part. If you go to this link, you will be able to match the number up: https://www.kaiserwillys.com/willys_jeep_serial_numbers Thanks
What is the size of each plate?
Willys Jeep Parts Tech:
Here are the measurements on the three plates: Shift Plate: 3-1/8" x 3-1/8" Caution Plate: 3-5/8" x 3-1/8" Serial Number Plate: 3-7/8" x 3-1/8" Thanks!
Here are the measurements on the three plates: Shift Plate: 3-1/8" x 3-1/8" Caution Plate: 3-5/8" x 3-1/8" Serial Number Plate: 3-7/8" x 3-1/8" Thanks!
YOU MIGHT ALSO BE INTERESTED IN
