Product Videos
Questions & Answers
Will this work on a 1951 M38? It has a L-134 engine. 12 volt, not the original. I know the manual oil pressure gauge will work. I will not be using the 24 volt gauge that the M38 had originally.
Willys Tech:
Yes im sure it would work just fine. You may just have to get adapter fittings at your local NAPA.
Yes im sure it would work just fine. You may just have to get adapter fittings at your local NAPA.
I have a 42 gpw with a buick 225 v6 - will this part work for me?
Willys Tech:
It will screw into the back of your gauge like original.
It will screw into the back of your gauge like original.
Will the A-1198-ST work with a Buick 6 cylinder engine? If not, what would? Thank you, thomas
Willys Jeep Parts Tech:
No, this is only for the flat head 4-cylinder engine. You'll have to make one up for the V6 engine. Thanks
No, this is only for the flat head 4-cylinder engine. You'll have to make one up for the V6 engine. Thanks
Is there a hose that attaches to the steel oil pressure line and the block? I bought the gauge and the steel line but the line is too short.
Willys Jeep Parts Tech:
Yes, there is. Order part number - A1198. Thanks
Yes, there is. Order part number - A1198. Thanks
Is there a grommet that goes in the firewall that the steel line goes thru?
Willys Jeep Parts Tech:
Yes, they used a grommet thru there. See part number: B1843
Yes, they used a grommet thru there. See part number: B1843
Will this fit a 53 M38A1? Thanks.
Willys Tech:
This is only for the vehicle listed above.
This is only for the vehicle listed above.
Where on the engine does this line attach? thanks.
Willys Tech:
There is a lower galley plug on the bottom drivers side rear corner of the block.
There is a lower galley plug on the bottom drivers side rear corner of the block.
do you have the rubber hose that goes between the engine and this steel line?
Willys Tech:
A1198 is the part number for the flex line.
A1198 is the part number for the flex line.
I have a 1953 M38A1- will this fit or do you have a steel line that will. I have an after market plastic hose replacement gage in the dash now and am going to replace it with a proper gage which calls for the steel line to the sending unit.
Willys Tech:
For the M38A1 you will have to make it. Your local Napa does sell preflared steel lines in different lengths you can bend up.
For the M38A1 you will have to make it. Your local Napa does sell preflared steel lines in different lengths you can bend up.
