Carburetor Specs - Wagon



Carburetor Illustration

Model: F4-134 L6-226
Carburetor:
Make Carter Carter Carter Carter
Model YF-951S or SA WGD-2052SA WCD-2204S YF-2467S
Flange 1 1/4" [3,17 cm.] 1 1/4" [3,17 cm.] 1 1/4" [3,17 cm.] 1 1/2" [3,81 cm.]
Primary Venturi 11/32" [8,73 mm.] 11/32" [8,73 mm.] 11/32" [8,73 mm.] 11/32" [8,73 mm.]
Main Venturi 1 1/4" [3,17 cm.] 1 1/16" [2,70 cm.] 1 1/8" [2,85 cm.] 1 5/16" [3,33 cm.]
Float Setting 5/16" [7,93 mm.] See note 3/16" [4,76 mm.] 9/32" [7,13 mm.]
Fuel Intake Vertical Spring Loaded Vertical Spring Loaded Vertical Spring Loaded Vertical Spring Loaded
Idle Air Bleed No. 56 Drill No. 54 Drill No. 55 Drill ……..
Idle Port .184" x .030"
[4,6 x 0,762 mm.]		 .160" x .030"
[4,06 x 0,762 mm.]		 .156" x .030"
[3,96 x 0,762mm.]		 .190" x .040"
[4,82 x 1,01 mm.]
Low Speed Jet No. 70 Drill No. 70 Drill No. 68 Drill No. 70 Drill
Metering Rod No. 75-806 No. 75-901 No. 75-1129 No. 75-1279
Jet Size .096" [2,43 mm.] .086" [2,18 mm.] .086" [2,18 mm.] .098" [2,48 mm.]
Accelerating Pump:
Discharge Jet No. 72 Drill No. 74 Drill No. 72 Drill No. 70 Drill
Intake Ball Check No. 72 Drill No. 40 Drill .115" -.120"
[2,9-3.0 mm.]		 No. 40 Drill
Discharge Check …….. No. 50 Drill No. 50 Drill ……..
Vacuum Restriction No. 55 Drill …….. …….. No. 55 Drill
Diaphragm Bleed No. 65 Drill …….. …….. No. 56 Drill
Vacuum Spark Port .055" [1,39 mm.] .045" [1,14 mm.] .063" [1,6 mm.] .125" x .041" [3,17 x 1,04 mm.]

NOTE: WGD-2052SA with solid needle: 9/32" [7,15 mm.]; with spring loaded needle: 7/32" [5,56 mm.].

* Excerpt from the Service Manual for Jeep Utility Vehicles page 112