Dana 18 Transfer Case Service Standards - CJ-5

Dana 18 transfer case shown for reference only - click here to shop for these parts by interactive diagram

Dana 18 Transfer Case Diagram

Looking for Transfer Case parts for your vintage Willys or Jeep? Shop Dana 18 parts by Category or by Diagram

Transfer Case

The transfer case is essentially a two-speed trans­mission located at the rear of the standard trans­mission which provides a low and direct gear. It also provides a means of connecting the power to the front axle. Transfer case gears are controlled by the driver through one rod and lever in the cab which provides two- or four-wheel drive and also a high and low gear. The shift lever to the extreme rear provides 2-wheel drive by disengaging all drive to the front wheels. First position forward provides high-range 4-wheel drive. Second position forward (neutral) disengages all power to the wheels and is used primarily to provide the neutral setting necessary for the use of power take-off equipment when the vehicle is stationary. The extreme forward position provides low-range 4-wheel drive. (K-17, p178)

Transfer Case Assembly

The installation of the assembly in the vehicle is the reverse of the removal operation covered in Par. K-5. Lubricate the pilot bearing in the flywheel and also lubricate the transmission and transfer case as out­lined in the "Lubrication Section". Be sure that the clutch pedal has 1" [25,4 cm.] free travel as outlined in the "Clutch Section". (K-23, p181)

* Excerpt from the Service Manual for Universal Jeep Vehicles pages 178, 181

RELATED VIDEOS: